[EDGEPOD-186] Add Ansible playbook for Aether Edge
Change-Id: I71d73a5a4fdf7e5ccf12df924597af6ab90a68b4
diff --git a/aether-playbook/inventory/sample/inventory.ini b/aether-playbook/inventory/sample/inventory.ini
new file mode 100644
index 0000000..1a8b175
--- /dev/null
+++ b/aether-playbook/inventory/sample/inventory.ini
@@ -0,0 +1,36 @@
+# Copyright 2020-present Open Networking Foundation
+#
+# Licensed under the Apache License, Version 2.0 (the "License");
+# you may not use this file except in compliance with the License.
+# You may obtain a copy of the License at
+#
+# http://www.apache.org/licenses/LICENSE-2.0
+#
+# Unless required by applicable law or agreed to in writing, software
+# distributed under the License is distributed on an "AS IS" BASIS,
+# WITHOUT WARRANTIES OR CONDITIONS OF ANY KIND, either express or implied.
+# See the License for the specific language governing permissions and
+# limitations under the License.
+
+# List of all nodes
+menlo-edge ansible_host=10.212.73.3
+
+# Specify a node to run k8s control plane and etcd
+# Note that the number of the nodes must be odd
+[kube-master]
+menlo-edge
+
+# Specify k8s worker nodes
+[kube-worker]
+menlo-edge
+
+# Specify a node to run UPF(SPGWU)
+# Make sure the node has SRIOV supported NIC
+[upf]
+menlo-edge
+
+# Specify a router that will serve SGI/S1U network gateway and the Internet connectivity to UE
+[router]
+menlo-edge
+
+#[accelleran]